Metal Etch Primer™

Metal Etch Primer™ is used as a first coat on bare ferrous metal surfaces and as an adhesion coat over non-ferrous metals.

Metal Etch Primer™ displays the following characteristics:
• Forms a tough, non chip film
• Good chemical and abrasion resistance
• Quick Drying
• Inhibits rust formation
• Waterborne for easy wash up
• No dangerous fumes from solvents
• Metal Etch Primer™ is used as a primer for all metal accessories e.g. drip edge, trim pieces, etc.
• Excellent adhesive to Kynar®, and silicone polyester based coatings.

Surface must be clean, oil and grease free and free of loosely adhering particles. All rusted areas must be sandblasted or wire brushed to remove any loose rust. Power washing of the general area to be coated is highly recommended for optimum bonding. Unless the metal is prepared to shop conditions, it is required to first apply one coat of Rust X-2020™ to the prepared surface.

Apply the Metal Etch Primer™ by brush, roller or spray. Allow to dry. Then coat with appropriate Sealoflex product and/or Sealoflex System within 48 hours.

Wash tools and equipment immediately after use with water. Cured Metal Etch Primer™ can be removed with Quickclean™ available from Sealoflex,Inc.

Do not apply Metal Etch Primer™ over existing asphalt, bituminous coatings or bituminous aluminum coatings.

For this and all related products: Please refer to individual product data sheets, product MSDSs, System Application Guides, Primer Chart and Fabric Chart.

Metal Etch Primer™ will cover approximately 250 sq.ft./gal.