Additive 100™ is easily incorporated into Sealoflex Pink® or Sealoflex Finish Coat™. It allows sufficient time for application before losing its effectiveness.
Additive 100™
Additive 100 - Primer for Promoting Adhesion
Additive 100™ is a used to promote adhesion on surfaces where adhesion is normally difficult (such as Kynar® coatings).
It is also used to conduct pull tests prior to the beginning of projects where adhesion may be questionable. A Pull Test determines which, if nay, Sealoflex Primer should be used to obtain optimal adhesion.
Click here for a printable version of the Additive 100™ product page, which includes Pull Test Procedure Instructions.
Advantages
Mixing
Add one pint (500 ml) of Additive 100™ to five gallons (20 litres) of Sealoflex Pink® or Sealoflex Finish Coat™ with sufficient agitation to thoroughly blend the two components but avoiding foaming. Use within 24 hours of mixing.
Precautions
HANDLING
CARE MUST BE TAKEN TO AVOID ANY CONTACT WITH THE SKIN AND EYES. When used in spray applications, particular casre must be taken to avoid oral and/or nasal ingestion. Eye protection, gloves and suitable clothing must be worn to avoid contact with skin and eyes. In addition, a suitable respirator must be worn for spray applications.
Where spillage of Additive 100™ occurs, the area should be thoroughly flushed with water. This will hydrolyze the Additive 100™ and make it easier to clean. If more rapid cleaning is desirable, a 5% solution acetic acid or a mineral acid can be used.
Use with adequate ventilation. Avoid contact with skin or eyes. Avoid breathing spray mist. In case of skin or eye contact, flush thoroughly with plenty of water. Contact a physician in cases of eye exposure.
Use with adequate ventilation. Avoid contact with skin or eyes. Avoid breathing spray mist. In case of skin or eye contact, flush thoroughly with plenty of water. Contact a physician in cases of eye exposure.
Color
Clear tan liquid.
Technical Data
Additive 100™ is a polyfunctional water borne adhesion promoter that enhances the bond of Sealoflex Pink® acrylic saturator or Sealoflex Finish Coat™ to metal surfaces that have been previously finished with Kynar® based coatings. Because it is highly functional, Sealoflex Pink® acrylic saturator or Sealoflex Finish Coat™ treated with Additive 100™ must be applied within twenty-four hours of treatment.
|
Type: |
Polyfunctional Aziridine |
|
Shelf Life and |
Store in a cool, dry, dark place. If stored under conditions of excessive heat for extended periods, Additive 100™ may discolor, deteriorate and even gel. |
|
Percent Active |
100% |
|
Viscosity: |
200 cps at 25˚F |
|
Density: |
8.9 lbs./gal |
|
Stability: |
12 months at room temperature |
|
Packaging: |
1 pint (500 ml) plastic containers |
Packaging
One pint (500 ml) plastic jars.
Limitations
Sealoflex Pink® or Sealoflex Finish Coat™ treated with Additive 100™ must be applied within twenty-four hours of mixing. After twenty-four hours, the Additive 100™ expires. Therefore, the remaining material must receive a 2nd dosage of Additive 100™.
