Buttergrade™

Buttergrade™ is used:
• To smooth and fill knot holes and seams between, plywood boards on decks
• To feather off ridges left by the application of Sealoflex fabric
• As a flexible spackling paste for interior and exterior use
• Joint compound for sheetrock

Buttergrade™ displays the following advantages:
• Easily applied with putty knife trowel
• Flexible when cured
• Fast drying
• Can be smoothed with sandpaper
• Water based for easy clean up
• Excellent adhesion to wood, metal, stucco, painted surfaces, concrete, brick and other surfaces.

Remove all oil and grease, grit and loose particles from the substrate. Prime where necessary. Refer to Sealoflex Priming Chart.

Apply Buttergrade™ with a trowel or putty knife to smooth out voids or imperfections.  If depth of void is greater than 1/8” apply in two or more layers allowing previous layer to dry before covering with a fresh application. If required, cured Buttergrade™ may be sanded to achieve a smooth finish. Overcoat with a Sealoflex product as soon as the Buttergrade™ is dry. With solvent based coatings, it is recommended to allow at least 24 hours drying time in dry conditions.

Drying time will be 1/2-2 hours depending on weather conditions.

Clean all equipment and tools immediately with water. Dried Buttergrade™ can be removed with Sealoflex Quickclean™ water-soluble solvent.

NOTE: Sand when dry, but within 24 hours of application.

For this and/or related products, please refer to individual product data sheets, System Application Guides, Products MSDS, Primer Chart, Fabric Chart.

Off White

1 gal. will be sufficient to prepare approximately 100-150 sq. ft.

1 and 5 gallon containers